Under drive motor plate is used to mount the drive motor to the side of the conveyor body extrusion. Plate attaches with included T-nut plate and fasteners. Boss locates the plate into the extrusion T slot. Bearing included for the drive roller shaft. Mounting pattern for 90° gear motor. Should not be used without the AFC-21 Under drive belt cover.
The AFSB-CLAMP HANDLE kit can be used in the standard and XS series knuckles (AFSB-2, AFSB290, AFSB-2XS, AFSB-2XS90, and the AFSB-2-2XS coupler) to make quick adjustments in the positioning of the arms. Remove one of the screws of the knuckle and add the spacer and handle. Once the position is set, tighten the remaining screws. The handle and spacer can then be removed and the original screw can be re-inserted, or the handle can be left on the knuckle.
This single arm Standard Series kit with a 6” link is ready to mount any standard series mounting
plate. This kit includes: (2) AFSB-1 bases, (2) AFSB-2 knuckles, (1) AFSB-3-6 link, and (1) AFSB-Clamp Handle.
This single arm Standard Series kit with an 8” link is ready to mount any standard series mounting plate. This kit includes: (2) AFSB-1 bases, (2) AFSB-2 knuckles, (1) AFSB-3-8 link, and (1) AFSB-Clamp Handle.
This dual arm Standard Series kit with 12” links is ready to mount any standard series mounting plate. This kit includes: (3) AFSB-1 bases, (4) AFSB-2 knuckles, (1) AFSB-290 tee knuckle, (1) AFSB-3T tee link, (2) AFSB-3-12 links, and (2) AFSB-Clamp Handles.
+65 6748 5517
info@jm-vistec.com
10 Kaki Bukit Ave 1, #07-06, Singapore 417942
